Viking · Denver
Range Repair
Ignition, simmer control and mile-high gas setup on Viking professional ranges and rangetops.
How it gets described on the phone
- Burner ticks away for a minute and never catches
- Simmer will not stay lit on the lowest setting
- Flames burn tall and orange and soot up the pans
- Griddle or grill section heats at one end only
Any of these is enough to work from. Model number and what changed just before it started are the two things that speed a visit up most.
What it usually is
Tested in this order
A burner that ticks and never lights is almost always electrical rather than a gas supply problem, and the order below is the order it gets tested in.
-
Cracked electrode or a chafed spark lead
The ticking is the spark generator doing its job. If nothing catches, the spark is jumping somewhere it should not — a hairline crack in the ceramic, or a lead rubbed through where it passes the burner box.
-
Sea-level orifices at 5,280 feet
There is roughly 17 per cent less air up here. A range still on its factory jets runs rich: tall orange flames, sooted pan bottoms, and a simmer that dies the moment you turn your back.
-
Grease in the burner box and blocked ports
Years of roasting put fat under the caps and into the ports. The flame goes ragged, the flame sensor stops reading it, and the safety valve shuts the burner down a minute after lighting.
Worth knowing. If a burner lights from a match but not from the spark, the fault is on the ignition circuit and the gas side is fine. That one distinction saves an hour of looking in the wrong place.
What it costs
What a range repair usually comes to
These are the ranges Viking work in Denver actually falls into — every kind of repair we carry out, so you can see where a range repair sits against the rest. Which end of a band your machine lands on depends on the part it needs and on how much cabinetry has to come out to reach it.
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
One figure for your own unit is agreed before anything is opened further or ordered, and the $89 service call is credited against it the moment you say go ahead. Nothing on this list is charged on top of a quote you have not seen.
Typical ranges · Viking · Denver
- Igniter or burner assembly
- $190–$420
- Oven thermostat or heating element
- $210–$480
- Refrigeration fan or defrost system
- $280–$690
- Dishwasher pump or control
- $200–$410
- Control board or touch panel
- $480–$620
- Compressor or sealed-system repair
- $1,370–$3,400
Worth the comparison. Going the other way — a comparable Viking replacement, before installation — runs $7,340–$16,940. Even the sealed-system band above is a fraction of that, which is why a machine like this is usually worth putting right rather than swapping out.
Reviews
Range Repair calls in Denver
Left after range repair visits across Denver.
4.9/ 5583 reviews
Two of the six burned tall and orange and were sooting the bottoms of my pans. He reseated the burner caps, cleaned the ports and checked pressure at the regulator. Clean blue flame across the top.
Nerissa B.Park Hill
Griddle got hot at the back and stayed cold at the front. One element leg had gone open, which he showed me on the meter. Done properly. Four stars only because the part took nine days.
Ulises M.Park Hill
Front burner ticked all evening and never caught. A cracked igniter, plus a spark wire chafed through where it passes the burner box. One visit, in a bungalow galley barely wide enough for two people.
Viggo N.Platt Park
Range Repair in Denver, booked in one call
Technicians out 8:00 am – 8:00 pm, seven days. The line is answered 24/7, and $89 covers the trip and the diagnosis.